ElecGear 4x TMR Joystick Replacement for PS5, DSE, Steam Deck and Other Controllers, Desoldering Heating Plate, TMR Hall Control Stick and Soldering Wick Repair Tools

Why it's a great deal

• [TMR Joysticks works with PS5/DSE] – 4x TMR stick replacement for PS5 (DS5 and Edge), Steam Deck and other controllers. The new electromagnetic thumbsticks is an upgraded hall effect stick. More linear, accurate, consistent and low power consumption. The new TMR sticks can be calibrated by the DS Tools on Github

• [Desoldering Tools included] – A copper heating plate melts all the 14 solder joints simultaneously simply with a soldering iron. Multi gauge braid wire performs better than desoldering wicks. PCB clamps and holder for DSE and other helping tools make it easier to desolder the problem stick off

• [Compatibility] – We’re listing 3 models of this TMR stick series. The difference is how the 2 sensors take Vcc power. It also works with other controllers that use the same Vcc/Gnd layout. The Green sensor takes Vcc on Pin3, while Orange on Pin1. Please study the index image and measure your controller PCB. Choose the correct model. One more thing to consider is how to calibrate your specific controller

• [Reminder] – 🔺1. Your soldering station should be more than 60Watt. A big and short soldering tip is vital. Teardown tools, other soldering tools and materials are required, however NOT included. 🔺2. Two lower corners of one sensor was pre-cut for DSE stick module. 🔺3. The unlocking wire needed to solder on the PCB to unlock the DSE module. Please view the demonstration video before operation